Set QC Charts preferences

Follow these steps on the QC Charts tab (of the Analysis page) to set hart preferences.

1. Open and filter the QC charts tab for an analysis. (See Open and filter an analysis’s QC Charts tab.)

2. Select  Settings to open the Preferences dialog.

3. Adjust the settings as you prefer.

   • Show Annotations — Select to show or hide annotation. See Annotate control charts.

   • Show Historical Data — Select to show or hide historical data. By default, each control chart shows values from historical data. Although independent of the selected analyses, these data points are sourced from previous analyses that exist in the user group.

   • Show Variables — Select the checkbox of each variable of interest (e.g., Protein Group Count, Peak Width (seconds)). Clear the checkbox of any you’re not interested in.

   • Process Variables Y Axis Range — Select the range for the y-axis for processed variables.

     • Min and Max Data Dependent — Both the minimum and maximum values depend on data.

     • Min is 0 and Max Data Dependent — The minimum value is set at 0 and the maximum value depends on data.

     • User Defined — Enter the minimum and maximum values.

4. Select Save.